Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - mikejs

Pages: [1]
Installation / added new user account not able to access website
« on: May 08, 2015, 11:43:11 AM »
Hi I have a clean install I have added domain name and name servers etc it is setup under however I want use for my own website so is it possible to have the control panel install on a sub domain so I can still use my domain as normal or will I need a domain for the control panel and another domain for my website ? 

if I try to access or

I get



CentOS Configuration / Re: error trying to add new user
« on: May 08, 2015, 11:02:14 AM »
Ok so it looks like it was because I was trying to use a secure password - any reason why special chars are not allowed for passwords ? a brute force attack could find most number letter passwords in a short period of time

Are you trying to use a sub domain ? you would need to add it under your control panel dns settings first so I have a sub domain system

if the sub domain has not been added the it will not be a valid domain

I just installed a fresh copy and it works fine

Thanks for the replies I don't want my root user to have a password so how can I remove the root password - and have another user as the admin for the control panel - or is it possible to use 2 factor login to make it a bit more secure



CentOS Configuration / error trying to add new user
« on: May 08, 2015, 10:13:40 AM »
Hi I have a fresh install I have checked my shared ip which is correct, for the name servers I assume I can use my domain name servers?

I have created a package - and then noticed a package is already created - Default

when I try to add a new user I get Warning! Username mikejs2 already exists in /etc/passwd! so no user gets added there is only one user I created prior to install

any suggestions ?


Hi I have just run a clean install all went fine for root login it says to use  ssh server root password I do not use a password to login I am using ssh to authenticate - so how can I login to the control panel or do I need to run a new install and use a password to connect ?



Pages: [1]