Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
1
CSF Firewall / When I turn on CSF Firewall, WireGuard (by weejewel/wg-easy) stops working.
« on: September 12, 2024, 05:39:17 PM »
Hello!
I am a lamer in Linux systems, so I use the CWP panel.
The system is installed Almalinux 9 and the CWP panel, I needed a VPN. I installed Wireguard with a script from weejewel/wg-easy.
I used the following commands to run:
In the config "/etc/csf/csf.conf" I entered the ports in "TCP_IN, TCP_OUT =51821" and in "UDP_IN, UDP_OUT=51820". Restarted Firewall. Doesn't help. I don't understand what I did wrong.
Maybe someone can help with advice?
Thanks in advance and sorry for my bad English.
I am a lamer in Linux systems, so I use the CWP panel.
The system is installed Almalinux 9 and the CWP panel, I needed a VPN. I installed Wireguard with a script from weejewel/wg-easy.
I used the following commands to run:
Code: [Select]
docker run -d --name=wg-easy -e WG_HOST=MY_IP -e UI_TRAFFIC_STATS=true -e WG_DEFAULT_DNS=8.8.8.8 -e PASSWORD=MY_PASS -v ~/.wg-easy:/etc/wireguard -p 51820:51820/udp -p 51821:51821/tcp --cap-add=NET_ADMIN --cap-add=SYS_MODULE --cap-add=NET_RAW --sysctl="net.ipv4.conf.all.src_valid_mark=1" --sysctl="net.ipv4.ip_forward=1" --restart unless-stopped weejewel/wg-easy
Everything starts and works fine, but as soon as I turn on Firewall, the service immediately becomes unavailable, I turn off Firewall, it works again.In the config "/etc/csf/csf.conf" I entered the ports in "TCP_IN, TCP_OUT =51821" and in "UDP_IN, UDP_OUT=51820". Restarted Firewall. Doesn't help. I don't understand what I did wrong.
Maybe someone can help with advice?
Thanks in advance and sorry for my bad English.
Pages: [1]
