Control Web Panel
WebPanel => CentOS-WebPanel GUI => Topic started by: naguibihelek on July 24, 2022, 09:07:02 PM
-
I am using LightSail and create a snapshot copy of a fresh installation of CWP.
The original installation where this was copied looks fine.
But the new one has no widgets on the dashboard.
See attached.
Nagui
-
Here is the image of my dashboard.
https://ibb.co/R4cgMQG
-
Did you already goto "CWP Settings -> Edit Settings" and enter the new VPS info (IP, etc)?
-
Thanks Starburst.
I thought I did. In rechecking. It was incorrect.
After correcting and rebooting. It is still the same.
Is there a command to rebuild that?
Thanks again.
Nagui
-
It pulls from the servers config.
Which means when you cloned the image it brought over the networking info.
Check/change that at: /etc/sysconfig/network-scripts/
If wrong, correct, and reboot then check that menu again.
Run "sh /scripts/cwp_update_all" to be safe.
If it not saving the settings, then something is corrupt in the image.
I've found out just installing CWP from scratch is faster, and then cut & past common .conf files.
-
Thanks again.
Which file has the IP address in etc/sysconfig/network-scripts/ ?
Could run update all
[root@server ~]# sh /scripts/cwp_update_all
/scripts/cwp_update_all: line 16: /usr/local/cwpsrv/htdocs/resources/admin/version.txt: No such file or directory
/scripts/cwp_update_all: line 17: /usr/local/cwpsrv/htdocs/admin/design/version.txt: No such file or directory
awk: cmd. line:1: {print
awk: cmd. line:1: ^ unexpected newline or end of string
awk: cmd. line:1: {print
awk: cmd. line:1: ^ unexpected newline or end of string
cat: /usr/local/cwpsrv/var/services/user_files/version.txt: No such file or directory
cat: /usr/local/cwpsrv/var/services/users/cwp_theme/version.txt: No such file or directory
awk: cmd. line:1: {print
awk: cmd. line:1: ^ unexpected newline or end of string
awk: cmd. line:1: {print
awk: cmd. line:1: ^ unexpected newline or end of string
I guess it's a job for tomorrow. Start from scratch.
Thanks for your help.
Nagui
-
In /etc/sysconfig/network-scripts/
Depends on how the image was setup/done. It's usually ifcfg-eth0
But have seen other names as well. If you only have 1 network port, there should only be 1 config file in there.
From you capture above, it looks like you are missing some CWP Admin files/directories.
Which leads me to think the image isn't complete or is corrupt. :/